Fiat 500 Replacement Key Fob
It's possible to change the battery if your 500 remote key fob isn't working. However, if you replace the battery but it does not work the issue may be elsewhere.
United Locksmith specializes in the creation of new keys for classic automobiles. We have the tools as well as the parts required for this type of service.
Dead Coin Battery
A dead battery is the main cause of your Fiat 500 keyfob not locking or unlocking the doors. The coin cell battery in the key fob will drain quickly when you don't utilize it frequently enough. If your remote began to show signs of weakening such as a loss of range or stopped working completely the battery could be dead.
Metal clips hold the battery securely within the key fob. If the clips aren't tight enough, they can cause contact issues, which could prevent the remote from receiving power. Use a flathead screwdriver remove the retaining clip and remove the battery. Be sure to choose an identical replacement battery kind of voltage, the same size, and specification as the original battery.
Water exposure can cause the key fob to corrode or become damaged. Even a small bath in soapy, warm water could damage the chip. It's best to keep your key fob in a dry location.
Water Damage
If your key fob doesn't work properly, it may be due to water damage. The rubber seals on key fobs protect them from being damaged by a tiny drizzle or splash of water. However, it's crucial to keep the keys from the ocean, washing machine, and pool.
The key fob has an electronic chip that sends a message to the immobilizer system in your car. This is the reason why your 500 can start or lock, but when the chip becomes wet, it can no longer function.
You can clean the inside electronics of your keyfob using isopropyl alcohol or an electronic cleaner to see whether they're still functioning. It is recommended to replace the key fob if it's submerged into salt water rather than attempting to fix it yourself.
A replacement fob may cost you a few dollars, but it's a lot less expensive than paying to have your Fiat 500 towed to a dealership and fixed there! fiat panda key fob replacement could also do it yourself by following some simple steps. Make sure you have the correct type of battery prior to opening your keyfob. This is a job that's much simpler than it appears and you can find step-by-step instructions on the internet for nearly any car key fob.
Faulty Chip
The chip inside the key fob communicates with the immobiliser on your vehicle to ensure that the vehicle will only start when the right keys are in place. If the chip is damaged or damaged in any way your car will not start.
Water damage or a dead cell phone battery are among the most common reasons for a faulty chip. It is best to hand over the job to a professional locksmith who can replace the chip in a short time and at a a reasonable price.
If your key fob will not function after being exposed to clean tap or rain water take the battery off. Clean the electronic component with an old towel. If the key fob still does not work it's probably an issue with the chip and must be replaced.
A few people turn to their dealer when in need of a new Fiat key fob, however it can be a costly alternative. United Locksmith is the best choice if you need your Fiat keyfob repaired at a reasonable cost. We have all the tools and knowledge required to repair your Fiat fob in a timely and professional way.
Faulty Receiver Module
Fiat key fobs transmit signals of up 50 feet away to the vehicle, which can unlock and close the doors (and start the vehicle if it has automatic transmissions). There are several reasons why the fob might not function. It could be due to a dead battery water damage, worn buttons or a problem with the receiver module or signal interference, or an electronic chip malfunctioning.
If the fob was located in an area that has experienced extreme trauma (such as being dropped onto the floor, or washed in a washing machine) it might not be able to connect with the Body Control Module (BCM) of the vehicle. This is because the BCM is an extremely secure system that will only accept signals from a genuine key and not any other.
If this is the case, you will require replacing your fob. A professional locksmith can handle the entire process of replacing your key including programming a new one for your 500. In fact, they can even provide you with a duplicate key that functions like the original fob (and costs a fraction of the cost).